Aluminum glass doors for home building work are popular. There are 2 types, which are swing glass doors and sliding glass doors. with details as follows
Note : Read more articles about building a house at trendyhome.co.th
- Sliding glass doors that can be pushed in, can be pushed out, suitable for interior doors. advantages and limitations
- Strong and durable in closing/opening the door. Over time
- Can’t focus on mosquito wire. which is different from sliding glass doors
- Not 100% soundproof because it has to leave a gap for the door to push in. or easily pushed out
- Sliding glass door slide slide It saves space in opening and closing. There are 2 types of floor rails and hanging rails.
- The advantages of the floor rails are that they are waterproof, splash proof, insect proof, and can be attached to the door wire. But there is a limitation, namely the door latch is not as strong as it should be.
- The advantages of hanging rails are that it is easy to slide, easier to use, more durable than door bolts. The limitation is that it is not 100% resistant to rain and insects.
Techniques and precautions, frequent problems
Aluminum doors with lower rails have disadvantages, namely, the door lock system is not very tight, easy to lose, and should choose a good design. The horse neck lock system will be more durable than the press type.
****After installing the aluminum glass door/window finished Have the glassworker sealant with a silicone sealant. The edge of all aluminum glass in detail.
The problem that often arises is when it rains, splashes on the glass. Rainwater tends to seep along the edges. aluminum mirror
Principles of dividing aluminum glass compartments with transport and moving work
Sturdy glass partitions are safe to move.
- 3 meter wide glass window
- Divided into 3 channels, 1 meter each.
- Not taller than 2 meters.
The widest distance that can be transported
- 3 meter wide glass window
- Divided into 2 channels, 1.5 meters each.
- Not taller than 2 meters.
In the case of glass compartment height 2.40 meters
- Use glass thickness 6 mm.
- 3 meter glass compartment
- Divided into 3 channels, each bouquet is 1 meter.
***In the case of the height of the glass compartment greater than or equal to 2.40 meters and a wide window Greater than or equal to 1.20 meters, not suitable for moving. It is recommended to go to the job site.
Building electrical work
Types of wires and the use of building a house VAF cable, 300 volt voltage resistant cable, available in both single-wire, double-wire and ground wire types walk in the trunk in a dry place The material is not resistant to ascent.
***Caution, VAF cable is strictly prohibited to be buried in the ground.
The THW-A cable is a 750 Volt power cable for general installation in both dry and wet areas. Popularly installed by walking in the air. or walk on insulators
***Caution, THW-A cable is strictly forbidden to be buried in the ground.
The THW cable is a 750 Volt, pressure resistant electrical cable intended for internal/external conduit applications or aerial walkways.
***Caution of THW cables is strictly forbidden to be buried in the ground. The material is not resistant to moisture.
Types of wires and their use
VCT cable is a round cable, and can bear a voltage of 750 volts. VCT cable can be used in a variety of applications such as general tool wiring, power plug cables, conduit work, walk in the trough, direct burial, buried conduit.
The NYY power cable is a 750 Volt power cable designed to be Resistant to the environment, suitable for walking in the ground or walking in the ground.
Standard core, type and size of wires, circuit breaker, in case of using VAF cables.
Consumer Unit has TIS. 1436-2540
+ RCBO system, electric shock-leakage protection device
- Size 45 A or not more than 50A
- For meter 15(45)A
Standard core, type and size of wires, circuit breaker, in case of using THW cables.
Consumer Unit has TIS. 1436-2540
+ RCBO system, electric shock protection device
- Size 45 A or not more than 50A
- For meter 15(45)A
electrical installation After installing the interior wall
- The electrical system must be planned beforehand that
- How many light points / light switches are there / where are they?
- How many power outlets / where are they located /
- TV/fan/refrigerator where are you
- Where are the water heaters and breakers located?
- Where are the air conditioners and breakers located?
- Consumer unit Where is it located? / Where is the ground wire nailed? / Where does the mains power come in?
Fixing objects to a gypsum wall/fiber cement wall
Fix the switch mask and plug mask for plasterboard wall 12 mm., use drywall screws to fix the metal strips to the wall first.. and then install the plug mask with Drywall screws, make it time to pull the plug The mask will not fall off the wall. damage the wall
Fasten the switch mask. and power socket For fiber cement board walls, thickness 8 mm. can use Drywall screws to mount directly without seals. because the wall is strong enough
- Sharp-tipped drywall screws for fixing low-water items directly to the wall without a bracket.
- Screw at the end of the drill for fixing objects that weigh very little – very much. Into the wall, there is a steel frame to support
- Butterfly cleats for hanging heavy objects. directly into the wall without a frame
